![]() |
![]() Road Switches
Weatherproof, ideal for activating sequences in car wash installations. Replaceable sealed switch sheathed in protective heavy rubber and mounted in a galvanized steel channel. Flanges with .25" holes facilitate mounting to concrete, asphalt, wood plank, etc. This heavy-duty road switch operates as a normally open, momentary switch, closing contact when pressed by any vehicle wheel. The advanced Controflex principle will give millions of cycles of performance when properly installed.
For ground installations 24 Volts or less is recommended. (Amp draw is 1/2 amp @ 24 Volt.) Pressure sensitivity is 20 lbs. Cross section excluding flanges is 2" wide x 7/16" thin. Standard lengths are 2 ft, 3 ft, or 5 ft. (Other sizes are available on special order.) Insert Ribbon Switches are a sealed contactor that is available as a replaceable item that slips into the protective rubber sheath of the RBMA Road Switches. 2', 3', 5' shown. (Other sizes are available on special order). End Protection Plate is a cast metal protection for ends of RBMA. Use when vehicles cannot be kept from end of switch. Dimensions are 2-1/2" x 4-1/2" x 1/2" thick. |
Additional Information


