Rotary Vane Pump, Low Flow, Stainless Steel, 1.8 Max GPM, V-Band, with Relief Valve, No Strainer

BUNA SEAL

These pumps are available for V-Band clamp mounting to 48Y frame motors. This series of pumps are also standard with built-in relief valves preset a 170 psi. Viton® seals are standard. Nominal speed on all units is 1725 rpm.

Series PO311: Stainless Steel pump body. Flows to 2.30 GPM. Standard with relief valve but is less strainer. Maximum pressure is 200 PSI. 3/8" FPT Ports.
Viton® is a registered trademark of DuPont Performance Elastomers

Manufacturer:

SKU: PBPO311V

VIEW CATALOG PAGE E0042

$164.00 / EA

Qty:

i h

Additional Information

Positive Displacement Rotary Vane Pumps: An excellent choice for handling clean fluids such as tire cleaners, presoak chemicals, spot-free RO water, foam brush solutions, oils, syrups, inks, dyes, acids, etc. Unique design handles liquids with low lubricating characteristics at relatively high pressures. Pumps should be protected from matter larger than 125 microns.

Pump Characteristics:

Viton® sealing parts for added chemical resistance (1300/1500/1600 & PO300 series)
Replaceable brass or stainless housings
Self-priming
Three-bearing design for pulley or direct drive
Carbon graphite internal vanes, bearings and liner provide no metal to metal contact for long life and quiet operation
Available with relief valves to protect against over pressure (1300/1500/1600 & PO300 series)
Mounting flanges for direct mounting to C-face motors or V-band mounting for "carbonator" motors with "y" frames
Maximum temperature is 150 Deg. F. (190 Deg. with special seals). Maximum viscosity is 500SSU.