Self Priming Centrifugal Pump Unit, Polyester with 5.5 HP Honda Engine, 2" FPT

LIGHTWEIGHT, CORROSION RESISTANT: Thermoplastic polyester construction resists corrosion by water.

FAST PRIMING: Will lift 25 feet in less than one minute.

HIGH CAPACITY: 1-1/2" size will pump 100 GPM; 2" size will pump 150 GPM and 3" size will pump 200 GPM.

PROTECTED SEAL: Pump out vanes on back of impeller reduces pressure and eliminates dirt in the seal area.

INTERCHANGEABILITY OF PARTS: All internal parts are interchangeable on 1-1/2" & 2" size (Pacer). Note: Hydraulic Units have same pump specifications.

PUMPS CAN BE USED FOR: Water • Most Fertilizers • Deicing Liquids • Most diluted agchemicals compatible with EPDM seal.
* With Roll Cage

Use of tough engineering thermoplastic makes this the most desirable pump for pumping liquid products. The pump "castings" are made of thermoplastic polyester or polypropylene which is noted for its outstanding chemical resistance. The pump "rubber" parts are molded of Viton® and EPDM.

Viton® is a registered trademark of DuPont Performance Elastomers